Thanks for the advise... (BD-Design)
Helo Bryan,
Try this one: ;-)
http://www.lowther.de/lowther/subwoofer/ats_atk.asp
I use Beyma 15G350 drivers in ATS. I have calculated (formula is on the old forum somewhere - I do not remember) that for 8 ohm driver you need 8mH coil for cut at 160Hz.
Olso see this:
http://www.solen.ca/6db.htm
I hope this will help. :Y:
Best Regards,
Gasper.
Complete thread:
- Please help with Klipschorn/Oris combo - GC, 2005-03-10, 17:00
- Please help with Klipschorn/Oris combo - GC, 2005-03-11, 02:01
- Please help with Klipschorn/Oris combo - robmatthew, 2006-06-14, 23:13
- Please help with Klipschorn/Oris combo - GC, 2005-03-11, 02:15
- Please help with Klipschorn/Oris combo - GC, 2005-03-11, 09:01
- Please help with Klipschorn/Oris combo - GC, 2005-03-11, 10:57
- Thanks for the advise... - GC, 2005-03-11, 14:10
- Thanks for the advise... - GC, 2005-03-11, 19:21
- Thanks for the advise... - GC, 2005-03-12, 15:18
- Thanks for the advise... - GC, 2005-03-13, 03:55
- Thanks for the advise... - GC, 2005-03-13, 11:20
- Please help with Klipschorn/Oris combo - GC, 2005-03-11, 02:01