New member, Oris 150 with Aer bd3 and ripoles 4 bd15 (BD-Design)
Hello
Would be a good idea to cut ripoles at 200 hz LR 4 order 24 db octave as i have now but cut the horn at 125 hz lr 4 order 24 db octave? This way i could get better bass integration as horns goes down to 150 hz.
Good idea but I am not sure how your ripole behaves at 200Hz?
Usually these have resonances...
Perhaps you can measure to see what the bass section outputs?
I suppose this can be done wiyh the Marchand as it works with modules.
It could...
I have the bd 15 in paralell, an 1 mm wire is enough?
Yes
Bert
--
BD-Design - Only the Best!
Complete thread:
- New member, Oris 150 with Aer bd3 and ripoles 4 bd15 - RLRB, 2019-11-02, 13:12
- New member, Oris 150 with Aer bd3 and ripoles 4 bd15 - Don Reid, 2019-11-04, 21:01
- New member, Oris 150 with Aer bd3 and ripoles 4 bd15 - RLRB, 2019-11-08, 23:45
- New member, Oris 150 with Aer bd3 and ripoles 4 bd15 - Bert, 2019-11-05, 11:20
- New member, Oris 150 with Aer bd3 and ripoles 4 bd15 - RLRB, 2019-11-16, 12:18
- New member, Oris 150 with Aer bd3 and ripoles 4 bd15 - Bert, 2019-11-16, 20:05
- New member, Oris 150 with Aer bd3 and ripoles 4 bd15 - RLRB, 2019-11-25, 20:38
- New member, Oris 150 with Aer bd3 and ripoles 4 bd15 - RLRB, 2019-12-10, 20:54
- New member, Oris 150 with Aer bd3 and ripoles 4 bd15 - RLRB, 2019-11-25, 20:38
- New member, Oris 150 with Aer bd3 and ripoles 4 bd15 - Bert, 2019-11-16, 20:05
- New member, Oris 150 with Aer bd3 and ripoles 4 bd15 - RLRB, 2019-11-16, 12:18
- New member, Oris 150 with Aer bd3 and ripoles 4 bd15 - Don Reid, 2019-11-04, 21:01