idea of a 4way horn system (Off Topic)
hi all
idea of a 4way horn-speaker system.
Not time aligned, but in compensation mid-bass horn and mid-high would create a
one point source.
30hz - ~ 120hz
Bass cabinet similar to bassmaGC
http://www.speakerstore.nl/index.php?l=nl&pg=11&c=18
driver cgn 18
http://www.bhivemotor.com/
~120hz - ~600hz
horn with 1m diameter
driver fane cres10mb
http://www.fane-acoustics.com/public_html/media/pdf_media/CRES10MB.PDF
~ 600hz - 20khz
horn mounted inside mid-bass horn 0,40cm diameter
bms4592nd
angelo
idea of a 4way horn system
Interesting, but it looks like a 3 way. Am I missing something.
idea of a 4way horn system
Interesting, but it looks like a 3 way. Am I missing something.
Yep, what you missed is the small print :
bms4592nd
which is a two way unit (mounted in the frontmost horn I'd say) ...
:biglol:
idea of a 4way horn system
Hi Angelo,
idea of a 4way horn-speaker system. Not time aligned, but in compensation mid-bass horn and mid-high would create a one point source.
Sorry but I do not get much thrill seeing this... I forsee too many problems with such a setup.
You already mentioned time-alignment so I can leave out that remark for the bass part. Pity, because when done properly will be the only way to have the real feeling of dynamics and giving the least interference of the frequency respons of each driver (acoustical cancellation and amplification - time is also phase!).
To have a real working point source (with all audible advantages) can only be done when the drivers are time aligned too....
Another critical point (at least for me) would the achieved rather high listening height.
You migth get a real good sounding system though (its all big enough for reality!) but it would not be a system for me.
ciao,
Bert
--
BD-Design - Only the Best!
Another idea...
....neither time aligned but that gives me some thrill!
http://www.hifi-musik.dk/?page=viewtopic&mode=reply&t=1377
Don't forget to scroll down on that page!
Ciao,
Bert
--
BD-Design - Only the Best!
idea of a 4way horn system
hi chris
was considering the bms4592nd as two way.
idea of a 4way horn system
hi bert
alternative would be above design. that approach
resolves time alignment.
what do u think ?
angelo
idea of a 4way horn system
Hi Angelo,
Better...
You still could use the bass horns but then used as a table closer to your listening position to have that one better time aligned too...
BTW, the filter for the bass and for the mid-bass will also delay. Just having the coils time-aligned is too simplistic...
Ciao,
Bert
--
BD-Design - Only the Best!
idea of a 4way horn system
hi bert
could u make these filters ? use such a basshorn in a 30sqm room close to the listener would be quit crazy
tomorrow get my orpheans, start to tweak around
angelo
idea of a 4way horn system
Hi Angelo,
could u make these filters ? use such a basshorn in a 30sqm room close to the listener would be quit crazy
I can only make a filter when I have all speakers here to play with. Unless it is a closed box with a driver that is known to me (i.e. correct TS-parameters) then it is an option. Anything else is too much influenced by other parameters and therefore hardly optimal to design a filter for that.
With the bass horns on their side and short feet underneath them would not make them too grazy...?
Having horns with 1m in diameter in such a small room would be more grazy!
tomorrow get my orpheans, start to tweak around
It is about time you receive them! Stupid customs there in Brazil...
Ciao,
Bert
--
BD-Design - Only the Best!
Another idea...
Pffffff. I thought my 5-sided horns were excentric..... :shame:
Ivo