oris filter (BD-Design)

by GC, Tuesday, May 31, 2005, 21:10 (6915 days ago) @ GC

Hi Merdy,

Hi is it possible you can repost your line filter, for the 150 will try
again in my new line stage i am building

Here is the basic filter you can start with.

[img]images/uploaded/image30.jpg[/img]

From there you can tune the filter to your room/taste/system. Increasing the first resistor gives deeper bass and lowering the second capacitor gives more mid-bass. Play with the values and listen to the changes so that you hear what you're doing.

also does the output pot must be 100k ,can i use a 1ok one

Such a low value will influence the filter too much. You could lower the values for the resistors (devided by 5) as used in the above filter to prevent that though but that means that you have to increase the value of the capacitors...

5 times lower resistor gives 5 times higher needed capacitance.

p.s will now work on a mtm horn array with oris altec front horns and my
bass horns ,no idea how it will end up but wifey ok if i sell all my other
stuff wish me luck

Good luck! :-P

Ciao,

Bert

Tags:
0