Question on Oris 200 wiring ...................... (Forum)

by Kevin @, Minneapolis, Thursday, May 09, 2019, 20:31 (331 days ago) @ Bert

> It depends on the bass system used. Is it part of the advised total combination in those days then this comment relates to that specific situation. Did your friend buy the complete setup from the seller?
[quote]
I am not sure which filter you're talking about though, is it the filter you wrote about a few days ago that is NOT connected? Is that filter supposed to be connected as advised by the seller to the Oris horns?

A reason for connecting the bass or mid-high horn out of phase could be when a 2nd order crossover is used which shifts phase 180 degrees... flipping phase makes that 0 or 360 which is then in phase.[/quote]

No the Oris 200, along with the Filter were bought from 1 seller and His Bass Cabinents were bought from a Different seller. The bass cabinets are an Onken Style with a Single 18 inch woofer in each Cabinet.

The Filter is the same one One I mentioned a couple days ago. It is supposed to be connected to the Bass Bins, not the Oris Horns as the Oris Horn Seller Mentioned this:

"The nice thing about the filter is that the Oris runs full range w/o
going thru a crossover. It works by taking a speaker level signal from
your main amp (so two sets of speaker wire comes from the amp driving
the Oris) and then sending a signal from 200Hz on down to the bass amp.
It's very simple and there's only a few resistors in the signal path."

This was 15 years ago that he bought these Oris 200 Horns -- So, information is Sketchy.

I guess we could try it and see what sounds better....


Complete thread:

 RSS Feed of thread