16 vs. 8 Ohm Taps on SET Amplifier (Drive Units)
I am considering getting a new amp and the issue came up of 8 vs. 16 ohm taps.
The new amp I am looking at, a Yamamoto A08-S, has single 8 ohm taps. A special 16 ohm output transformer can be purchased at extra cost.
I was curious to see what my current amp is using, so I opened it up and looked: They have 2,4,8, and 16 ohm taps. I am using the 8 ohm tap into my Oris 200s with AER MD3s. It sounds damn good on the 8 ohm tap.
I know when it comes to impedance issues things are not straightforward, but I would still appreciate comments and experiences on 8 vs. 16 ohm taps for the AER MD3.
Complete thread:
- 16 vs. 8 Ohm Taps on SET Amplifier - Cappy, 2006-12-05, 01:49
- 16 vs. 8 Ohm Taps on SET Amplifier - Cappy, 2006-12-05, 04:08
- 16 vs. 8 Ohm Taps on SET Amplifier - Bert, 2006-12-05, 09:44
- 16 vs. 8 Ohm Taps on SET Amplifier - Cappy, 2006-12-05, 16:06
- 16 vs. 8 Ohm Taps on SET Amplifier - Bert, 2006-12-05, 16:14
- 16 vs. 8 Ohm Taps on SET Amplifier - Cappy, 2006-12-05, 16:31
- 16 vs. 8 Ohm Taps on SET Amplifier - Cappy, 2006-12-05, 16:47
- 16 vs. 8 Ohm Taps on SET Amplifier - Bert, 2006-12-06, 15:44
- 16 vs. 8 Ohm Taps on SET Amplifier - Cappy, 2006-12-06, 19:09
- 16 vs. 8 Ohm Taps on SET Amplifier - Bert, 2006-12-06, 15:44
- 16 vs. 8 Ohm Taps on SET Amplifier - Cappy, 2006-12-05, 16:47
- 16 vs. 8 Ohm Taps on SET Amplifier - Cappy, 2006-12-05, 16:31
- 16 vs. 8 Ohm Taps on SET Amplifier - Bert, 2006-12-05, 16:14
- 16 vs. 8 Ohm Taps on SET Amplifier - Cappy, 2006-12-05, 16:06