Bert measurements for the horn mounts? (Oris Horns)
Hi John,
Hi Bert if you would be so kind and post measurements for the 150 stands?
Would save me some hastle.Till later and thxs for your time and help
The tubes to hold are 250mm in diameter so the round cut-out for the stand should be 250mm plus the thickness of soft rubber to put in between them. The length of the stand should not be longer than 275mm (the length of the back chamber) and the heigth at the lowest point larger than 30mm.
It is not too critical, the back of the horn mouth should lean against the front of the bass enclosure.
Ciao,
Bert
--
BD-Design - Only the Best!
Complete thread:
- Oris 150 horn mount for oris ref bass ca - JohnK, 2006-09-21, 16:00
- Oris 150 horn mount for oris ref bass ca - Bert, 2006-09-21, 16:13
- Bert measurements for the horn mounts? - JohnK, 2006-09-26, 17:27
- Bert measurements for the horn mounts? - Bert, 2006-09-26, 19:38
- Bert measurements for the horn mounts? - JohnK, 2006-09-26, 17:27
- Thxs for the help, picture looks good - JohnK, 2006-09-23, 17:01
- Oris 150 horn mount for oris ref bass ca - Bert, 2006-09-21, 16:13